CHRYSLER BIG BLOCK 440 CUDA AND OTHER PULLEY SINGLE GROOVE POWER STEERING FEDERAL PUMP-PRESS FIT 5/8" USING ORIGINAL BRACKETS

 

CHRYSLER POLISHED SINGLE GROOVE POWER STEERING PULLEY - PRESS FIT 5/8"

 

V-Belt Dodge / Chrysler power steering pump pulley designed to fit a Small Block and Big Block Chrysler Engines with the Federal Pump. 5/8" Press Fit Shaft. Fits most Big Block Chrysler Engines except for those with keyway shaft (1970 440 Cuda and others)

Equivalent to Chrysler part number 82668 2608

This is a 1 groove, V-Belt power Chrysler power steering pump pulley. Fits most Small and Big Block Chrysler engines (318, 340 & 360). 

Designed to be used with stock power steering brackets (Chrysler power steering brackets). Fits 5/8" Press Fit shaft on Federal Pump.

THIS PULLEY HAS A POLISHED FINISH, NOT SATIN. THIS IS TO FIT SAGINAW PUMPS AND CHRYSLER MOPAR VEHICLES WITH FEDERAL PUMPS FITTED

DO NOT USE THIS TO REPLACE KEYWAY FIT PULLEYS. ONLY ONES WITH THE PRESS FIT HOLE 

THESE PULLEYS ARE EXTREMELY HIGH QUALITY. WE HAVE A FULL SELECTION OF PULLEYS IN STOCK FOR FORD

FITS THE FOLLOWING APPLICATIONS: 

6.80" DIAMETER, 0.42" HEIGHT. DIMENSION (B)  OVERALL HEIGHT 1.18" 

 

5/8" Press Fit V-Belt power steering pulley designed to fit the Federal Power Steering Pump. For use with 5/8" Press fit Federal power steering pump .  

DO NOT USE THIS TO REPLACE KEYWAY FIT PULLEYS. ONLY ONES WITH THE PRESS FIT HOLE 

IF IN DOUBT REFER TO THIS DRAWING AND MEASURE YOUR PULLEY

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: