CHRYSLER BIG BLOCK 440 CUDA AND OTHER PULLEY SINGLE GROOVE POWER STEERING PUMP-SAGINAW KEYWAY FIT 5/8" USING ORIGINAL BRACKETS

 

CHRYSLER POLISHED SINGLE GROOVE POWER STEERING PULLEY - KEYWAY FIT 5/8"

 

V-Belt Dodge / Chrysler power steering pump pulley designed to fit a Big Block Chrysler Engines with keyway shaft (1970 440 Cuda and others)

Not for use with Our Racing Bracket ( Contact us for correct Bracket and Pulley.)

 

Interchanges with Chrysler part number 82668 1189

This is a 1 groove, V-Belt power Chrysler power steering pump pulley. Fits most Small and Big Block Chrysler engines (318, 340 & 360). 

Designed to be used with stock power steering brackets (Chrysler power steering brackets). Fits 5/8" Key-way shaft on Saginaw Pump.

THIS PULLEY HAS A POLISHED FINISH, NOT SATIN. THIS IS TO FIT SAGINAW PUMPS AND CHRYSLER MOPAR VEHICLES WITH SAGINAW PUMPS FITTED

DO NOT USE THIS TO REPLACE PRESS FIT PULLEYS. ONLY ONES WITH THE KEYWAY FIT HOLE 

THESE PULLEYS ARE EXTREMELY HIGH QUALITY. WE HAVE A FULL SELECTION OF PULLEYS IN STOCK FOR FORD

FITS THE FOLLOWING APPLICATIONS: 

6.70" DIAMETER, 0.58" HEIGHT. DIMENSION (B)  OVERALL HEIGHT 0.95" 

 

5/8" Keyway Fit V-Belt power steering pulley designed to fit the Saginaw Power Steering Pump. For use with 5/8" Keyway fit Saginaw power steering pump (Pear Shaped Pump).  

DO NOT USE THIS TO REPLACE PRESS FIT PULLEYS. ONLY ONES WITH THE KEYWAY FIT HOLE 

IF IN DOUBT REFER TO THIS DRAWING AND MEASURE YOUR PULLEY

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: